Beam iridium SatDOCK 9555 User Manual download pdf (Page 34)

Send Tracking Position

In order to send a tracking message, the following condition must

be fullled.

1. The GPS receiver has acquired enough satellite signals

and navigational data to calculate a positional solution (x).

2. The 9555 handset is registered with the Iridium network.

3. Tracking is congured and enabled via the SDMS

The Track LED will stay off if the Tracking function is

disabled. It will turn solid GREEN if all of the above conditions

are satised. Otherwise, it will ash in GREEN if the Tracking

function is enabled but no GPS x and/or Iridium registration.

To manually send a tracking message of the current location

1. Apply a single press to the Track button. A beep will

sound (if congured in the SDMS).

Activate Alert Mode

Alert mode can be activated by one of the following two methods:

1. Press and hold both the Track and Ring/Mute buttons

together for 2 seconds. A single beep will sound (if

congured in the SDMS).

2. If enabled by the SDMS, press and hold the external

panic button (optionally wired into the Alert Loop wires).

Once triggered into the Alert mode, the Track LED turns RED.

The message then attempts to be sent.

The Track LED will ash in RED when the alert message is

sent. (Rate: 1.5sec off, 1.5sec on, etc)

The Track LED will ash in ORANGE when the alert message

is acknowledged by a remote host.

(Rate: 1sec off, 4sec on, etc)

Clearing an Alert

To clear the alert mode press and hold the Track button for

seven seconds. A single beep will sound, and the LED will show

re-armed state (GREEN).

NOTE:

Tracking and/or Alert Modes MUST be congured

in the SDMS before use. These two functions are

disabled by default.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 51 52

No comments

Beam iridium SatDOCK 9555 User Manual Page 34