Beam SD7 series User Manual download pdf (Page 3)

" NOTE: NON FOG LIGHT CONTROL BRITE BOX REQUIRES 10 AMP FUSE!

STEP 11: REINSTALL BOTH HEADLIGHTS

Figure Reference: Figure 2

" Plug Brite Box's plug into headlight bulb (both sides of vehicle).

" Reinstall side marker light into headlight assembly (both sides of vehicle).

" Reinstall headlights by first reinstalling pop clip and then the expander clips and bolts.

" IMPORTANT! IF YOU REMOVED ANY SENSORS FROM DRIVER'S HEADLIGHT, MAKE SURE THEY ARE REINSTALLED!

STEP 12: TEST BRITE BOX FOR PROPER OPERATION

" Turn low beams ON, keep fog light switch OFF

" Turn on HIGH beams on. You will notice greatly improved headlight output and coverage due to the low beams and fog light

illuminating.

NOTE:

DO NOT USE BRITE BOX WITH SO CALLED "EXTRA OR SUPER BRIGHT BULBS". EXPERIENCE HAS SHOWN THAT THESE BULBS ARE NOT

MUCH BRIGHTER THAN STOCK BULBS, BURN OUT QUICKLY, ARE VERY COSTLY AND GENERATE MORE HEAT THAN MOST HEADLIGHT SYS-

TEMS CAN WITHSTAND. INSTALLING BRITE BOX WITH STANDARD WATTAGE BULBS (120 WATTS OR LESS FOR HIGH + LOW BEAM) PRO-

VIDES SUPERIOR ILLUMINATION (BETTER BEAM PATTERN WITH LESS FATIGUE) THAN A SLIGHTLY BRIGHTER INFERIOR BEAM PATTERN

PROVIDED BY THESE "SUPER BRIGHT BULBS".

BECAUSE OF THEIR SUPERIOR QUALITY, MORE AUTO MANUFACTURERS SPECIFY OSRAM / SYLVANIA HEADLIGHT BULBS

AS OEM EQUIPMENT THAN ALL OTHER BRANDS COMBINED.

OUR EXPERIENCE CONFIRMS THE QUALITY OF OSRAM / SYLVANIA BULBS IN THAT THEY LAST THE LONGEST AND HAVE

THE LOWEST FAILURE RATE.

We have seen bulb brands that you should avoid. These brands are WAGNER and GE (General Electric). These brands are poorly

designed (in our opinion) in that they use VERY thin wires to deliver current to the bulb filaments. This causes problems in bulb

life and reliability. It is common to see these wires break or deform which causes the bulb to prematurely fail. In fact, it is

probably best to avoid any headlight bulbs whose reliability you are not sure of.

SOME FREE ADVICE ABOUT HEADLIGHT BULBS:

• Stick with Osram / Sylvania brand bulbs. Don't second guess the car makers.

• Carry spares in your glove box. It's cheap insurance. Changing a bulb usually takes only a few minutes, but you

cannot replace a burned out one without a spare. If you have quality spares, you will never have to settle for cheap

bulbs because that is the only thing that "Bob's Boonie Market And Service Station" stocks (if any at all).

TECH AND ORDER LINE: (970) 879-4201

BAKER AUTO ACCESSORIES

2955 Village Dr. #5

Steamboat Springs, CO 80488

Fax: (970) 879-6097

BOOST YOUR FACTORY INSTALLED FOG LIGHT

OUTPUT BY 70% WITH THE FAMOUS

BULBZILLA / FOGZILLA HARNESS KIT!

SEE:

http://thebritebox.com/bulbzilla.fogzilla.mod.html

FOR COMPLETE DETAILS!

1 2 3 4

No comments

Beam SD7 series User Manual Page 3